Cisco UCS and Native VLAN Tagging

Published on April 29, 2014 under Cisco · Tagged Cisco UCS · Read in about 1 min (78 words)

Building out some new servers today I came across an issue where the servers would have no network connectivity even though the vNICs were properly tagged and assign a VLAN ID. Upon further research, I noticed that “Native VLAN” was not selected. This is a must for any operating system that does not do VLAN Tagging such as ESXi.

So remember to set the VLAN to Native if using an operating system that does not support VLAN tagging!

Share this post
comments powered by Disqus